Petesquared Dust Boot

This listing is for a physical copy of the Petesqured Dust Boot, listed with collaboration and permission from Pete.  If you are looking for the digital design, please visit Pete's site: Petesquared23.com.  If you are looking for the hardware portions of the boot, please utilize the link above to provide Pete with affiliate sales.

Features:

• Split brush design with 8 magnets each side and tabs for a STRONG hold
• Custom made brush with 0.5mm filament size, specifically made for dust boots
• Many spacer sizes for compatibility with a huge variety of spindles
• Connector for 4" hose for high cfm suction
• Custom modeled vortex design by Petesquared
• Colors are available upon request

There are a few changes to the design from standard design from Petesquared:

• Magnets used are 10x3 instead of the standard 10x4
• Hose adapters are connected to the vortex piece in the model, reducing the need for fasteners, but does not allow the ability to swap these adapters out like Pete's design. The 4" Adapter is the most common and is the standard configuration.  If you need a different hose size, please reach out.
• Please reach out with any questions.