P2P CNC Dust Boot Replacement Brush — Full & Split | Fits All P2P Boots

Trimmed your brush too short? Worn it down after a big job? Don't replace the whole boot — just swap the brush. This is the exact same replacement brush used on all P2P dust boots, available in full and split styles to match your setup.

Why keep a spare on hand:

• ✂️ Trim one short, keep one long — switch between them for different tooling lengths without missing a beat
• 🧲 Magnetic snap-on attachment — swaps in seconds, no tools
• 🇺🇸 USA-made nylon bristles — same quality as what ships with every new P2P boot
• 🔁 Full or Split — Full for standard setups, Split for hinged/split boots that allow faster tool changes

Compatible with: All Pixels to Prototype dust boots — v2, v3, Onefinity Elite, XCarve Pro, and more.

A $25 spare brush is a lot cheaper than a ruined job.

🥾 Need a Boot to Go With It?

If you're replacing a worn-out brush, it might be time to check whether your boot is due for an upgrade too. Here's the full P2P dust boot lineup — each one ships with a brush included: